Concorde goes crazy

Archive > Technical discussions

Concorde goes crazy

<< < (2/3) > >>

Anonymous:
:P thats a main rasen concoded got grounded there too fragile :o i never gotto go in one :@:[ they also got grounded couse the take off and landing so many crashed :) :]:]

EHM-1343 Jonathan:
I would reccomend that you should register on the forum aswell!

EHM-1001 Robert:
Hi guys!

I hava both FS2002 and FS2004. I modified the dynamics a bit to both versions, and made available at EHM website. I must say too, that I do not have any problems with the plane.

Could you tell me more circumstances about the problem? For example do you use the afterburner for supersonic jump? Usually I start the flight at FL350@M0.9, when I turn on the afterburner, gain some speed and then start to climb. Climb rate is about 2000 fpm. If you climb too fast, the bird lost speed and may fall down like any other plane. But if the climb and acceleration goes parallel there will not be any problem. At around M1.7 you can turn off the afterburner and it will blast you until M2.0. Of course, in the final phase you should decrease the climb to 1000...1500 fpm.

If this "tactic" still do not help you, probably an add-on messes on your FS installation. Maybe FSUIPC, or a bad panel, or some weather add-on...I do not know.

Orkku:
Well i don't think it's handling because this thing always happens right after takeoff. I take gears up and turn afterburner off. I don't even try to turn anywhere. Just flying straight. Suddenly it starts turning to the right and not long before the thing is spinning around like crazy.

I have looked speed carefully and it's not that. There is always enough speed. And it's not overspeeding either.

And i have FS2004.

Edit: It works now. I reinstalled it again but for some reason this time it started to work. :|

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version