Archive > Technical discussions

Dornier 328-120

(1/2) > >>

EHM-1744 Danny:
Can anyone tell me how I can shut the Dornier 328-120 out??
Today I had finished a flight, and I want to shut the plane down with ctrl+e. But this doesn't work. I also killed the battery, but whit no result.

Because of this, I couldn't send the pirep with Pro Pilot.

EHM-1343 Jonathan:
ctrl+shift+f1 cuts the fuel suply. Or you can go to engine panel by clicking on the respective clickspot. Then manually pulling down the fuel cuttoff levers. But they both have the same effect

EHM-1744 Danny:
Thank you!
But I have one last question....
When I fly in the Dornier 328-120 and I'm climbing after take-off, I put automatic pilot on.
I also click on the HDG and ALT buttons. But when I set the speed up to 250 in the speed hold selector the real speed goes higher when I set the gas-handle open.

How can I set the speed on 250 in the speed hold selector the right way?

EHM-1001 Robert:
Well, it depends on the panel you use, but on the Ken Mitchell panel recommended, there is not Autothrottle function.

EHM-1744 Danny:
I use the default panel that comes with the aircraft....
But the next problem apears... I finished a flight from EHAM to LKKV. I have shutdown the aircraft and send the pirep. I have locked a new flight from LKKV to EHAM, but when I look at my altimeter I noticed that it stands on 2500 ft. But the aircraft stands on the ground... With the first landing I had the same problem. The real hight was 1200 ft but the altimeter says 2650 ft.

How is possible?

Navigation

[0] Message Index

[#] Next page