Archive > Support

Flight Logger Error

(1/2) > >>

EHM-1570 Bruce:
I was about to fly the PMDG B744 but I get a Pen003 Engines started without beacons on, but the beacons are on. has this been reported before?.

EHM-0948 Bruno:
Hi,

The Boeing 747 from PMDG has a strange behaviour with our Flight Logger.
For instance, if you turn one engine one, the Flight Logger receives information from the FSUIPC that the airplane has turned on all engines :| ..

So, what I suggest it to use it very carefully... I mean, don't do the pre-flight procedures too quickly, do it all by the book, because I flow with B747 often and now I can fly without receiving any penalties.

Regards,

EHM-1570 Bruce:
Hi Bruno
 I have gone through the pre-flight checks OK, but when I start the engines every thing is OK until I start engine Number 1, as soon as engine 1 starts up I get Pen003, I can start the engines in any order, but as soon as engine 1 starts I get the Pen003, any ideas??.

EHM-0948 Bruno:
Try to press the "L" key before starting engines. Then turn off the landing lights.

See if works please ;)

EHM-1570 Bruce:
Hi Bruno
I have tried your suggestion but no success. I have tried all combinations of the lights. I can start engines 2, 3 and 4 with no penalties, this would show that the beacons are on but when i start engine 1 I get Pen 003. I am using a 64 bit processor I wonder if this is the problem

Navigation

[0] Message Index

[#] Next page