Archive > Technical discussions
BAE146-300QT Model / Behavior problem
EHM-1001 Robert:
I do not know those panels, but as I mentioned before, panels can totally alter the flight dynamics sometimes. Once I discovered similar thing with an Airbus A330 panel :s
EHM-1945 Christophe:
Roberto, thank you for the input. I'll check on that side of the problem. I will check if the panel could be partly the cause of my problem.
Cheers
Kristoff
EHM-1465 Dominic:
Christophe,
I use the 'baepanelproject' panels (both BAe 146 and Avro ARJ) and find them excellent. However, to ensure proper flight behaviour you must follow the installation instructions contained in the manual... Have you read through this section? It sets out what all the air files are for - the panel is designed to work with all the commonly available BAe 146 models and Matthias (the designer) has included an airfile and aircraft cfg file for each one to ensure it performs as expected.
So if in doubt, I'd say reinstall the plane and panel as indicated in the manual and you should have no problems.
Also, it's an excellent panel but you have to ensure you follow the checklist as the hydraulics etc are very realistically designed so your control surfaces won't work if the hydraulic pumps are off (just as an example). Worth checking visually that the elevator moves as commanded before you leave the stand... This is the main thing I can think of that would stop your aircraft rotating when you tried to take off.
Let me know how you get on. Good luck!
EHM-1945 Christophe:
Dominic,
Thank you for this information. I've installed the panel using the manual and I'm following the checklist coming along. In fact this panel is quite good, even if the graphics are a bit old compare to some other recent panels. Anyway, I think my problem is coming from the FsP Payload file. I tried to flight the bird without FsP (Anyway, flying cargo with FsP is useless), and I had no more problem.
Thank you to everybody for your inputs and help
Cheers
Kristoff
Navigation
[0] Message Index
[*] Previous page
Go to full version