Archive > ProPilot Main Forum
I\'m still flying!!
EHM-1442 Luis:
Hi. another victim....eheheheh
I crashed on final approach rwy 14 at HKNW (leg 7)....
I was too low and there is a tree near the beginning of the rwy.....and i was thinking....if i pass inside the tree,will Propilot remark that as a crash?.....eheheheheh...now i know the answer.....it is yes..........CRASH.
When i sent the crash report....i received an error ( duplicate key 1234)....i don't know what this means....
Now i must wait to see if i can continue the event after the suspension days....
EHM-1442 Luis:
Something is not right, because i'm not able to send this crash report.
I tried 4 times and when i confirm to send, i see this line:
"Duplicate entry '32767' for key 1"
After this, each time i enter in ProPilot Division, i'm advised to send the crash report.
So i think the report is not going his way out......
EHM-0948 Bruno:
@Javier: Nope, that leg is to be made by night ;D
@Luis: Solved out. We had send that number of emails on the system :) .. And the variable that identifies that quantity reached to his maximum.
Regards,
EHM-1821 Javier:
rgr that, mr president! ;D:]\
That will put our skills to the test!;D
EHM-1980 Brian:
--- Quote ---Originally posted by EHM-0948 Bruno
Hi,
The beacon lights problem normally is related with you use the "auto-start engines" mode (CTRL+E).
To avoid it do the following thing:
With your cold and dark panel do:
1. Turn on all the generators.
2. Turn on all the lights except the LAND one.
3. Start MANUALLY the engines by clicking-and-hold on every engine until the N2 fires up (select EI2 on the right PFD for this).
This way I can assure you don't get beacon penalties. If you start with CTRL+E then you get it somehow ...
--- End quote ---
hi bruno/peter,
i had this problem when i did my first pro pilot flight and the simplest suggestion to fix it is as follows:
when parked at the gate with engines and lights off - just press the 'L' button on your keyboard this will turn on all lights including beacons and then continue to press CTRL+E to start your engines - you should get no error message for beacon lights not being turned on.
It worked for me so hope it helps ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version