Archive > Technical discussions

FlightLogger

(1/2) > >>

EHM-2383 Ian:
Hi
I am new to Euroharmony and to using Flightlogger, so I apologise if this matter has been covered before or elsewhere. There are one or two issues that it would be helpful if I could have clarified for me. For Flightlogger....
1. It states that it is possible to enter the number of passengers being carried on a flight. My pirep always shows the maximum number for the aircraft and I can't seem to find a way to change that.
2. When I changed altimeter pressure to standard after FL180, I was informed on the screen that I had received a penalty for NOT doing this!!
3. Engine start times, take-off times, etc. do not seem to match those on FS for the actual flight.
Thanks for any comments you have on this - even if it is to direct me to where I can read about these things.
Ian

EHM-1821 Javier:
Hi Ian,

I can only help you with 2), sometimes there is more than one altimeter on the panel, with the second probably hidden somewhere and thus didn't get changed to 2992/1013, it's best to tap "B" when at FL180, this will ensure that you will definitely not get the penalty ;)

EHM-2383 Ian:
Thanks Javier. Will do that.

EHM-1980 Brian:
In relation to your first question - can you not adjust the amount of passengers in the 'fuel & payload' section of FS itself? Does flight logger not monitor this information from the game itself? Could be way off the mark but just wondering....

EHM-2383 Ian:
That's a possibility. I'll try that and see what happens.

Navigation

[0] Message Index

[#] Next page