Community Discussion > Chit Chat

DIY Drone

(1/1)

EHM-2387 Eric-Jan:
My little side hobby project flying thinghy

Here's the first "Proof of Principle" set-up:
DetailsAn Arduino board is going to be the flight controller. Here it's coupled to the output of a receiver (FS-i6) as 4-axis input (Pitch, Roll, Yaw, and Throttle), and an LCD screen as output to verify the signals are received OK, and can be interpreted, calculated with, and output.


DetailsThe signal range should be 1000 to 2000 microseconds pulse-length. So 1500 is mid-range.
This bit works!  ;D

Navigation

[0] Message Index