Archive > Ask EuroHarmony

EHM webtitles.

<< < (7/12) > >>

EHM-0962 Zhen Yi:
You mean we need 1GB and above of ram to run FS at high FPS? :o

EHM-1123 Dejan:

--- Quote ---Originally posted by EHM-0962
You mean we need 1GB and above of ram to run FS at high FPS? :o
--- End quote ---


I wouldn't know exactly.. but I think so from my experience, a large improvement!
When I had 1GB, FS with all sliders maxed, ran at 20-24FPS, now I locked it at 30FPS.:)
Maybe it's because my motherboard has DualDDR system...meaning:
4 memory slots in 2 pairs(black & blue), so if U fill only a pair(2x512) memory runs at 400Mhz. But if U fill both pairs(4x512Mb) memory runs double time (800Mhz)
Maybe that's what caused an improvement

EHM-0654 Murray:

--- Quote ---Originally posted by SirRoberto
Hey folks, with what PC specs can you run the B738 product? PMDG says for best performance, a PIV with 512MB RAM recommended. Is that true?
--- End quote ---

(Slow to see this post, but...) It works well enough on my Athlon XP 1900+ with 768MB RAM...

EHM-0654 Murray:

--- Quote ---Originally posted by EHM-1365
@Murray: Thanks for all your help...it was my first flight....havnt dared fly with it since...scared the life out of me :D. Will try again and see what happens....I may also be a bit extreme in the ammount[sic] of throttle used for taxiing ;)
--- End quote ---

(So slow in noticing posts that could do with a response...) If you spool the throttle to c.30%N1 to overcome inertia, then spool back to 22-24%N1, that should be more than enough for 18-23kts GS... Of course, fuel/passenger load will have an effect.

EHM-1539 Pierre:
It runs quite well in the virtual cockpit version with my P4 1.8 and a GeForce4 Ti4600 (1GO DDR RAM though)
For the 800/900 series I recommend fs2crew, it's a must :)
Copilot, flight attendant, gate agent, pushback guy, etc...
www.fs2crew.com

Yeah at the beginning the plane needs some work on the procedures and the FMS if you're not used to it, but it's so much worth it !

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version