EuroHarmony Community Forums

Archive => EuroHarmony VA => Old Forum => Technical discussions => Topic started by: EHM-1971 Mike on September 12, 2006, 04:59:27 pm

Title: Need help with Dorner 328 panel
Post by: EHM-1971 Mike on September 12, 2006, 04:59:27 pm

I have installed Ken Mitchell's panel for the Dornier 328. After following the directions in the readme, the panel is there but no gauges. Can someone hold my hand and walk me through step by step. I am a computer dummy and have no idea what I am doing.

Title: Need help with Dorner 328 panel
Post by: EHM-1001 Robert on September 12, 2006, 08:05:52 pm

Hi 1971 !

This is a common question , do not worry :)

Inside the ZIP file of the package, you will find 2 folders. If you unzip the package to a temporary place, you will get those folders. The PANEL folder always goes to the desired aircraft's own folder.

1. Copy all files from the unzipped Panel folder to ..\FS2004\Aircraft\ehm_d328\Panel. By this you copied all the panel background and gauge configuration to the correct place.

2. Copy all files (und subfolders) from the unzipped Gauges folder to ..\FS2004\Gauges. By this you copied all the gauges to the correct place. After this you MUST see the complete panel.

Good luck, Robert ;)

Title: Need help with Dorner 328 panel
Post by: EHM-1971 Mike on September 13, 2006, 02:57:24 am

Robert, thank you for your help. I now have the panel installed, working, and loving it.

Thanks again,
Mike