EuroHarmony Community Forums

Archive => EuroHarmony VA => Old Forum => Technical discussions => Topic started by: EHM-1744 Danny on February 11, 2007, 12:38:32 pm

Title: Problem using FSnavigator
Post by: EHM-1744 Danny on February 11, 2007, 12:38:32 pm

I have installed FSnavigator to my FS9.
But my vertical speed isn't working... When I shut down FSnavigator the problem is gone.
When I run FSnavigator and I set:
HDG to set+hold
ALT to set manualy
SPEED to set+hold

The problem is gone, but I have to set these values manualy.
Is there solution to run FSnavigator automaticly with vertical speed normaly running?

Title: Problem using FSnavigator
Post by: EHM-0654 Murray on February 11, 2007, 01:20:23 pm

Danny, when you say the VS isn't working, what is the exact symptom you are seeing?

Title: Problem using FSnavigator
Post by: EHM-1744 Danny on February 11, 2007, 03:13:32 pm

I see in the VS screen only 000 or 100...

Title: Problem using FSnavigator
Post by: EHM-1001 Robert on February 11, 2007, 04:37:24 pm

You can select your airplane type in FSNAV so it can calculate you the vertical profile of the route after the plane capabilities. Also you can modify the maximal climb speed there. Maybe you selected a slow airplane.

Title: Problem using FSnavigator
Post by: EHM-1744 Danny on February 11, 2007, 05:03:11 pm

Quote

Origineel gepost door EHM-1001 Robert
You can select your airplane type in FSNAV so it can calculate you the vertical profile of the route after the plane capabilities. Also you can modify the maximal climb speed there. Maybe you selected a slow airplane.

No, I have selected the right aircraft and still the VS says 0000 or 0100...